Formation of Banded Microstructures with Rapid Intercritical Annealing of Cold-Rolled Sheet Steel
About this book[edit | edit source]
The effects of heating rate in the range of 0.3 to 693 °C/s on transformations during inter-critical annealing of a cold-rolled 0.12C-1.4Mn-0.02Nb steel with either a ferrite-pearlite or ferrite-spheroidized carbide microstructure were evaluated. Heating rates were selected to impart different predicted degrees of ferrite recrystallization present at the onset of austenite formation. Rapid heating minimized ferrite recrystallization with both prior microstructures and minimized pearlite spheroidization in the ferrite-pearlite condition, and austenite formation occurred preferentially in recovered ferrite regions as opposed to along recrystallized ferrite boundaries. Martensite was evenly distributed in slowly heated steels because austenite formed on recrystallized, equiaxed, ferrite boundaries. With rapid heating, austenite formed in directionally oriented recovered ferrite, which increased the degree of banding. The greatest degree of banding was found with intermediate heating rates leading to partial recrystallization, because austenite formed preferentially in the remaining recovered ferrite, which was located in bands along the rolling direction. Ferrite-spheroidized carbide microstructures had somewhat reduced martensite banding when compared to the ferrite-pearlite condition, where elongated pearlite enhanced banded austenite leading to banding in transformed microstructures.
Useful Off-site Resources[edit | edit source]
- Springer link[1]
- ↑ Thomas, Larrin S.; Matlock, David K. (2018-10-01). "Formation of Banded Microstructures with Rapid Intercritical Annealing of Cold-Rolled Sheet Steel". Metallurgical and Materials Transactions A. 49 (10): 4456–4473. doi:10.1007/s11661-018-4742-9. ISSN 1543-1940.